Super Purchasing for Magnetic cell phone holder Export to Bolivia

Our eternal pursuits are the attitude of "regard the market, regard the custom, regard the science" and the theory of "quality the basic, trust the first and management the advanced" for Super Purchasing for Magnetic cell phone holder Export to Bolivia, With superb service and quality, and an enterprise of foreign trade featuring validity and competitiveness, that will be trusted and welcomed by its clients and creates happiness to its employees.


magnetic holder 4magnetic holder 3magnetic car holder 2

  • Previous:
  • Next:


  • ECKLIN na silnych magnesach neodymowych i gruba blacha stalowa. Siła odpychania jest tak potężna, że człowiek ich nie złączy, czyli w sumie sama darmowa energia, pewnie z wszechobecnego eteru lub z energii próżni. Przy wykonaniu PRAWIDŁOWO ZMODYFIKOWANEGO ECKLINA jako POMPA ENERGII na mechaniczną, będzie działać, że hoho.
    Nawet przez tę blachę stalową magnesy przyciągają stal od rozbudowanego PMH Leedskalnina zawieszonego na linie.

    Wystarczy wykonać resztę konstrukcji tego ECKLINA zgodnie z rysunkami na stronie: http://www.autoelektryczne.cba.pl
    oraz instrukcja projektowa w filmiku: https://www.youtube.com/watch?v=EbFKGt_inaw&feature=youtu.be
    Czyli ta moda jest trendy – 21. wiek – widać moc.
    Takich efektów nawet nie mają jeszcze gadźety do gier online, nawet za duże pieniądze.
    Prace badawczo-rozwojowe, B+R, B&R, R&D – uzyskuje się efekty, że hoho.
    Widać jednak, że fizyka prawdziwa jest ciekawa i żywa, może nawet UFO jej używa, chociaż każdy wie, że go nie ma.



    This is a quickly tossed together schoolgirl/bedini ‘motor’. There is no charge battery hooked up. It is using 4AA batteries that are only giving around 4v under load. This consumed ~80mA…pulsed of course. The speed continued to pick up until it was decided it was getting dangerous. lol
    The coil is a bifilar wrapped leftover Teflon tape bobin. Power coil is 30AWG and the trigger is 34AWG……80ft of wire was used. The ceramic magnets used are 3/4″ cheepies that were probably from the local arts and crafts store….don’t know for sure. The 2n3055 transistor was recovered from some dead electronic….also…don’t know for sure. The rotor is and old hard drive disc glued to a piece of wood with some electrical tape rolls rubber banded to the bottom for weight and height. Rotor will rotate whichever way you start it. The pot is leftover from and old project it is 1k and the resistor is 220….leftover from another project.
    The coil was not wrapped all perfect…there is way too much wire connecting everything….the power source is not high enough voltage, the rotor is too big among other things that could make this work much better. The pot and resistor are connected from positive to the base. The trigger is wired from the negative to the base. The power coil is wired from the positive to the collector. The coil will ‘sing’ when it will run.
    I am not responsible if you hurt yourself…so build these things at your own risk. Magnets have flown off of these motors and punctured lungs….you have been warned.

    TOP